Alarm and Indicator Unit PILOT B10MLX

The PILOT B10MLX has ten channels, which can be adapted for for alarm or indicator functions, as specified by the customer.
There are push buttons for Reset and Test.
Power, failure input contacts and relay output are connected to a terminal at the rear of the unit.


Alarm and Indication

When an alarm channel is activated, the output relay is activated after the programmed delay time and the alarm LED lights with a steady light.
Simultanously the corresponding channel LED indicates the position of the failure with a flashing light.

When an indicator channel is activated, the corresponding channel LED lights with a steady light until the input signal disappears.

Reset function

The output relay is released by pressing the Reset-button. If the failure remains, the alarm LED darkens and the corresponding channel LED changes to a steady light until the failure disappears.
If the failure disappears before the unit has been reset, the alarm remains until the Reset-button is pressed. This causes the output relay to release and the alarm and channel LEDīs to darken.

Test function

A function test of the unit is activated by pressing the Test-button. This causes the alarm channel LEDīs to flash and the output relay to activate.
The indicator channel LED`s show a steady light.

Accessories and options

PILOT B10MLX can be delivered with:
- built in transformer for 110 or 230 VAC power input
- built in adapter for 48 - 110 VDC power input
- protected enclosure for IP 54
- se also Accessories

More information

For more information plese send a message to:
PILOT Monitor System