The PILOT B10MXP has ten inputs with adjustable alarm
delay times. Inside the unit there is one potentiometer for each channel, which
can be adjusted to an alarm time delay from 0,2 to 35 seconds using a
small standard screw driver.
The unit has one output relay.
There are push buttons for Reset and Test.
Power, failure contacts and relay outputs are connected at the rear of the unit.
The PILOT B10MXP-2 is similar to PILOT B10MXP, but the unit
has two output relays, programmable to be activated for a selected
input channel (example: two different alarm priorities, A and B).
When a failure occurs, one of the output relays (A or B) is activated after the
programmed delay time and the alarm LED (A or B) lights with a steady light.
Simultanously the corresponding channel LED indicates the position
of the failure with a flashing light.
PILOT B10MXP andMXP-2 can be delivered with:
- built in transformer for 110 or 230 VAC power input
- built in adapter for 48 - 110 VDC power input
- protected enclosure for IP 54
- se also Accessories
For more information plese send a message to:
PILOT Monitor System